Mercury Remote Control 30 Foot | Ignition and Engine Wiring Harness | 84-896537K29

MercuryRemote Control 30 Foot | Ignition and Engine Wiring Harness | 84-896537K29

The Mercury Remote Control 30-Foot Wiring Harness is designed for installations that require a single, continuous wiring run between the helm and the outboard. Its full 30-foot length helps eliminate the need for multiple extensions and supports a cleaner, more organized rigging layout. This harness is commonly used on larger boats or installations with longer helm distances where a one-piece solution simplifies routing.

Reducing connection points helps support consistent signal transfer between the control station and the engine. Proper routing and secure installation can also make future service access easier while helping limit wear caused by vibration, movement, or tight bends along the rigging path.

Key Features

• 30-Foot Continuous HarnessProvides a single, uninterrupted wiring run from helm to engine
• Fourteen-Pin Engine ConnectorSupports ignition and engine signal communication
• Integrated Ignition LeadsAllows direct connection to the ignition switch where applicable
• Marine-Grade ConstructionDesigned to handle vibration, moisture, and typical engine-compartment heat

Engine & System Compatibility

• Mercury outboards
• Mechanical remote control systems
• ECM-equipped engines
• Two-stroke and four-stroke Mercury outboard platforms

Important Notes

• Confirm existing connector style and pin configuration before ordering
• Route and secure the harness properly during installation
• Avoid strain, abrasion, and tight bends along the wiring path
• Verify proper ignition and engine communication after installation

FAQs

1) What is this 30-foot remote control harness used for?
It provides a full-length wiring connection between the helm and the engine, eliminating the need for multiple extensions.

2) When is a one-piece harness preferred over extensions?
It is preferred on larger boats or longer helm runs where reducing connection points improves reliability and simplifies rigging.

3) Does this harness include ignition wiring?
Yes. It includes integrated ignition leads for direct connection where applicable.

4) What connector type does this harness use?
It uses a fourteen-pin engine connector for ignition and engine signal communication.

5) Why choose an OEM Mercury wiring harness?
OEM harnesses are built to Mercury electrical specifications, helping ensure reliable signal transfer, proper resistance values, and long-term durability.